info@tecamsrl.it 02 97271273

SPECIAL DESIGN AND EQUIPMENT

THE INITIAL IDEA
It all begins with a design and concept phase of the set-up with paper, pen and the best tool that the human being has: the brain.
The design of an outfitting, for example to integrate a roll-off tank on a truck or to attach a snow blade to a bulldozer, typically begins with a hypothesis of a 2D technical drawing of the project already accompanied by documents relating to the actual implementation.
3D DESIGN

Using 3D CAD design software allows us to concretely explore design ideas, visualize concepts and simulate equipment operation in the real world.
We can design the different components of a machine, choose the materials to sell them interact and verify their functionality before the project is sent to production.
STRUCTURAL CALCULATIONS AND FEM ANALYSIS

For finite element analysis (FEM) we use a series of software tools that allow us to carry out engineering simulations. These instruments reproduce a real test bench, where the mechanical piece we are going to design can undergo static or dynamic stresses, or it can deform or even undergo a temperature variation.

This translates into a reduction in the number of physical prototypes made, reducing time and costs. Some FEM operations:
- Preliminary calculation during the design
- Check at the end of the design
- Optimization of existing products in terms of weight, materials, functionality

SPECIAL EQUIPMENT

Thanks to new design and production technologies, we guarantee a rapid response even to requests for new customized fittings. What if the equipment is still suitable while the vehicle has completed its life cycle? Then we plan interventions for the transfer of equipment or tanks of different types from one vehicle to another, after careful planning. The final test is essential to close the procedure.

MOVING EQUIPMENT FROM OLD VEHICLE TO ANY ONE

Is your vehicle old or damaged, but is the equipment still in good condition? In TECAM we are able to transfer the equipment to another vehicle and we also take care of the checking of the vehicle through the Civil Motorization.

PHASE 1
REMOVING THE ROLL-OFF TANK

PHASE 2
TRANSFER OF A NEW VEHICLE

PHASE 3
TESTING

ROLL-OFF EQUIPMENT

Among the interventions most requested by customers, there is the solution with a roll-off waste collection equipment and lifters.

SALT SPREADER

We are able to install and test salt spreading equipment on different types of vehicles.

TILTING AND OVERWRAPPED PLATFORM

An example of an outfitting with a tipper bed and side panels (on a Porter Tipper truck)

TANK WITH LEAF VACUUM

In this example, at the request of the customer Tecam has developed an integrated solution on a commercial truck in which a tilting tank has been installed coupled with the use of a leaf vacuuming system.

SNOW BLADE ATTACHMENTS

We design and manufacture snow blade attachments and interfaces, in this example on a truck

TANKS FOR THE COLLECTION OF EXHAUSTED VEGETABLE OILS

Preparation of a tank for the collection of exhausted oils, equipped with a suction pump and cans. Installed on Renault Maxity truck or similar.

SNOW BLADES ON TRACTORS

Installing a snow blade on a tractor

SNOW BLADES + SALT SPREADER

In the example in the photo, we have set up a truck with a snow blade and integrated salt spreader

SNOW BLADES ON SCRAPER

In this case the snow blade was mounted on a scraper.